...
The following controls make up the program control area:
Cycle Start
Single Block
Feedhold
Optional Pause
Stop
Reset
Feed rate slider and 100% button
Max velocity slider and 100% button
Documentation for each of these controls is provided in the application by tool tips and extended tool tips. To see an extended tool tip, place the mouse pointer over the control and then leave the mouse stationary for 3 seconds. The extended tool tip will appear, disappearing when the mouse is moved again.
...
This area is used in conjunction with jogging. Please refer to instructions about jogging., covered in detail here: /wiki/spaces/ROB/pages/728924253