...
To command a specific RPM in PathPilot, you enter your desired speed, and then you MUST press enter for the machine to accept the commanded speed. Then proceed to hit FWD or REV.
Verify all safety switches are closed
Reason: A door is open, tripping the machine into reset or emergency stop condition.
Verify that the spindle door is closed.
If you mill is equipped with the optional door safety switch, make sure your enclosure doors are closed, and the switch is latched.
Inspect and/or re-tension the belt
...
Examine the spindle cover door to verify that it's closed, being held closed, and the switch is being depressed.
If your mill is equipped with door safety switches, make sure your enclose doors are closed.
Reset the brake resistor’s thermal switch
...