...
...
...
...
...
...
...
...
If you purchased an Operator Console, finish the enclosure installation, then proceed to install the console. That process can be found here.
Install the Controller Arm
...
Find the four M4 screws and the VESA plate included with the controller. Then, mount the VESA plate to the PathPilot Controller VESA Mount (PN 50382). Make sure to put it flat side down with the keyholes toward the monitor.
...
Connect all USB accessories to the controller:
Jog Shuttle (PN 30616) (Optional)
Keyboard
Mouse
Monitor
Connect the monitor's video cable to the controller.
Route the loose end of the video cable toward the monitor, and then connect it to the monitor.
Connect the power supply to the controller.
Connect the loose end of the power supply to one of the Controller/Monitor cables provided.
Route the power cables to the electrical cabinet.
Connect the power supply for the controller to any of the Accessory power outlets on the back of the electrical cabinet.
Find the Ethernet cable, and then connect it to the Controller Communications outlet on the side of the electrical cabinet.
Route the loose end of the Ethernet cable toward the controller and then connect it.
Secure the wire loom, Ethernet cable, and power supply cables to the Controller Arm with six wire tie mounts and six cable ties.
...
This is a section of the 1100MX operator's manual. To view the whole manual, go to Tormach document UM10586.
If you have additional questions, we can help. Create a support ticket with Tormach Technical Support at tormach.com/how-to-submit-a-support-ticket for guidance on how to proceed.