1100MX Enclosure Kit Installation
...
NOTE: If any items are missing, we can help. Create a support ticket with Tormach Technical Support at tormach.com/how-to-submit-a-support-ticket for guidance on how to proceed.
...
Install the Left Side Panel
Attach the left side panel to the left rear panel with five M5 × 0.8 - 10 screws.
...
Attach the left side panel to the left chip pan with five M6 × 1.0 - 12 screws.
...
Install the Left Side Window Retainers
...
Install the Left Front Panel
Attach the left front panel to the left chip pan with two M6 × 1.0 - 12 screws.
...
Attach the left front panel to the left side panel with eight M5 × 0.8 - 10 screws.
...
Install the Enclosure Splice Plate
...
Install the Rear Splash Shield
Attach the rear splash shield to the right chip pan below the electrical cabinet with four M6 × 1.0 - 12 screws.
Install the Linear Rails
Complete the following steps in the order listed:
...
Use a multimeter to verify the ground connection of both floodlights:
Measure the resistance between the floodlight's power connector ground pin (the middle pin on the three-prong connector) and the floodlight's bracket screw.
Read the OHMS value that displays. The value should be less than 5 OHMS. If the value is greater than 5 OHMS, don't install the floodlight. Create a support ticket with Tormach Technical Support at tormach.com/how-to-submit-a-support-ticket for guidance on how to proceed.
Position one floodlight over the opening on the right top panel. Take care not to drop the light through the opening into the enclosure.
Attach one floodlight retainer to either side of the lights with two sets of two M5 × 0.8 - 10 screws.
Verify that the floodlight is centered over the opening before hand-tightening the floodlight retainers.
...