1100MX Enclosure Kit Installation
...
NOTE: If any items are missing, we can help. Create a support ticket with Tormach Technical Support at tormach.com/how-to-submit-a-support-ticket for guidance on how to proceed.
...
Install the Upper Front Panel
Attach the front upper panel (with the threaded holes facing up) to the right and left front panels with two sets of two M5 × 0.8 - 10 screws.
...
Attach the front upper panel to the right and left top panels with four M5 × 0.8 - 10 screws.
...
Install the Front Lower Panel
Attach the front lower panel to the right and left front panels with two sets of two M5 × 0.8 - 10 screws.
...
Attach the front lower panel to the right and left chip pans with four M5 × 0.8 - 10 screws.
...
Install the Rear Splash Shield
...
Use a multimeter to verify the ground connection of both floodlights:
Measure the resistance between the floodlight's power connector ground pin (the middle pin on the three-prong connector) and the floodlight's bracket screw.
Read the OHMS value that displays. The value should be less than 5 OHMS. If the value is greater than 5 OHMS, don't install the floodlight. Create a support ticket with Tormach Technical Support at tormach.com/how-to-submit-a-support-ticket for guidance on how to proceed.
Position one floodlight over the opening on the right top panel. Take care not to drop the light through the opening into the enclosure.
Attach one floodlight retainer to either side of the lights with two sets of two M5 × 0.8 - 10 screws.
Verify that the floodlight is centered over the opening before hand-tightening the floodlight retainers.
...