Page Comparison

...

1. Using a saw, cut the board to width and length.  Mark and drill the holes with a a 1/4 in. drill bit.

2. Use a layout square to locate the center of the board and mark it.  This is X0Y0 location.

3. Attach the board securely to the xsTECH Router table using bolts, washers, and wingnuts.

4. Load the CO2_DRAGSTER_FIXTURE.nc program.

5. Install the 4mm compression cutter, PN 39173 as Tool 1 (T1)

6. Reference, and then set the work offset X0Y0Z0 at the location marked on the board.

• How do I reference the xsTECH Router?

• How do I set X-, Y-, and Z-axis work offsets on the xsTECH Router?

1. Press Cycle Start to run the program and cut the fixture

2. Remove the plate.  Use countersunk wood screws to secure the dragster blank to the plate from the bottom. 

...