...
The controller is the computer that runs PathPilot and controls your CNC machine. While the controller itself could be different (a tower, a brix, rev c, rev d, an operator console, etc.), they perform the same function in controlling your machine and providing you with a friendly user interface.
Replace the CMOS
...
Battery (stuck at Pathpilot splash screen)
Reason: The CMOS battery is dead.
Click here to see how to replace your CMOS battery!
Reseat the
...
Power Cable
Reason: The PathPilot controller isn't plugged in to an outlet.
Unplug and re-plug the controller’s power cable from both the outlet and the controller.
Restore
...
Power to the
...
Controller
Reason: The circuit breaker tripped or a fuse is blown.
If the monitor and the controller both don't have power:
Examine the power cables for damage or exposed wires and replace if needed.
Reset the CB3 circuit breaker.
...
Start the
...
Controller with
...
Only the
...
Monitor Connected
Reason: There is a USB issue.
...