...
The controller is the computer that runs PathPilot and controls your CNC machine. While the controller itself could be different (a tower, a brix, rev c, rev d, an operator console, etc.), they perform the same function in controlling your machine and providing you with a friendly user interface.
...
Replace the CMOS Battery (Stuck at Pathpilot Splash Screen)
Reason: The CMOS battery is dead.
Click here to see how to replace your CMOS battery!
Reseat the Power Cable
Reason: The PathPilot controller isn't plugged in to an outlet.
Unplug and re-plug the controller’s power cable from both the outlet and the controller.
Restore
...
Power to the
...
Controller
Reason: The circuit breaker tripped or a fuse is blown.
Make sure the outlet you have your controller plugged into is active, by performing a voltage test.
Replace the
...
Video Cable
Reason: The video cable is disconnected from the PathPilot controller.
For monitor troubleshooting steps, go to
...
...
...
...
...
...
...
...
...
...
Replace the CMOS battery (stuck at Pathpilot splash screen)
Reason: The CMOS battery is dead.
...
Start the
...
Controller With Only the Monitor Connected
Reason: There is a USB issue.
...