Basic Installation Procedure
...
Refer to documentation that ships with Lifting Bar Kit for more information on use. Do not attempt to lift mill from above using any other method. If using an engine hoist, refer to the following table to determine the minimum distance necessary to straddle stand between hoist legs.
Machine | Measurement |
PCNC 1100 | 37” |
PCNC 770 | 29” |
...
Lifting from Below
It is also possible to lift the mill from below by inserting steel bars into two sets of opposing 7/8” diameter holes located in the machine base. The bars must be a minimum of 32” in length and should be made of solid steel. Do not use hollow pipe to lift mill.
...
Install the cast iron Tool Tray using provided screws to attach it to left side of machine table.
Install Drip Tray
Unstrap stainless steel Drip Tray from pallet; use provided screws to install.
...
Looking for more information?
This is a section of the PCNC 1100 operator's manual. To view the whole manual, go to Tormach document UM10349.
If you have additional questions, we can help. Create a support ticket with Tormach Technical Support at tormach.com/how-to-submit-a-support-ticket for guidance on how to proceed.