Page Comparison

...

• CO2 DRAGSTER DEMO 1 ROUGHING.nc 

  View file
  name CO2 DRAGSTER DEMO1 ROUGHING.txt

• CO2 DRAGSTER DEMO 1 FINISHING.nc,  an optional finishing program that can be run after the roughing program to provide a smooth finish.

  View file
  name CO2 DRAGSTER DEMO 1 FINISHING.txt

• CO2 DRAGSTER DEMO FIXTURE.nc, a program for cutting the fixture plate from a 1/4" piece of MDF or Plywood.

...

CO2 Dragster Demo 1 can be cut on the xsTECH router in a single setup. There are two programs:

• CO2 Dragster Demo 1 Roughing.nc is the roughing program.

  View file
  name CO2 DRAGSTER DEMO1 ROUGHING.txt

• CO2 Dragster Demo 1 Finishing.nc is an optional tool path for finishing

  View file
  name CO2 DRAGSTER DEMO 1 FINISHING.txt

...

For finishing (optional): T2 is a 2mm carbide ballnose end mill, PN 39171

• How do I use the PathPilot Tool Table?

Set up the tool setter

If you decide the run the finishing program you will want to setup the tool setter to measure the heights of the tools:

• How do I use the electronic tool setter?

Set up the workpiece and fixture

...

Install Tool 1 in the spindle.  

• How do I install tools on the xsTECH Router?

Find the work offset (X0Y0Z0)

The work offset for the program is located top back left corner of the stock box.

• How do I set X-, Y-, and Z-axis work offsets on the xsTECH Router?

...

Load the demo program and run the program.

...