...
...
...
...
Purpose
This document gives instructions on installing and configuring the Door Lock Switch Kit on a mill.
...
NOTE: If any items are missing, we can help. Create a support ticket with Tormach Technical Support at tormach.com/how-to-submit-a-support-ticket for guidance on how to proceed.
...
Flat-blade screwdriver
Metric hex wrench set
Phillips screwdriver
Setup
Complete the following steps in the order listed:
...
Turn the door lock override switch to the locked position with a flat-blade screwdriver.
Find the screw for the door lock override switch that you set aside in Step 6. Then, put it back to secure the door lock override switch in the locked position.
Power on the machine and the PathPilot controller.
Turn the Main Disconnect switch to ON on the side of the electrical cabinet.
Twist out the machine's red Emergency Stop button, which enables movement to the machine axes and the spindle.
Press the Reset button.
Bring the machine out of reset and reference it.
Update PathPilot
Before using the Door Lock Switch Kit, you must make sure that the PathPilot controller is updated to PathPilot v2.1.6 (or newer). This version of PathPilot has settings required to use the Door Lock Switch Kit.
...
Install an Update File from a USB Drive
| Anchor | ||||
|---|---|---|---|---|
|
From the PathPilot support center, download the most recent PathPilot update file.
Transfer the PathPilot update file to a USB drive.
Put the USB drive into the PathPilot controller.
Confirm that the PathPilot controller is powered on and out of Reset mode.
From the Status tab, select Update.
...
Select the desired update file, and then select Update.
The update file is installed on the PathPilot controller.Follow the on-screen instructions to restart the PathPilot controller.
Enable the Door Lock Switch Kit
Supported with:
...
If you have a Door Lock Switch Kit, you must first enable it in PathPilot.
...