...
| Table of Contents | ||||||
|---|---|---|---|---|---|---|
|
General ATC Maintenance and Troubleshooting
| Widget Connector | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
This video applies for all M Style Atc’s. Not everything will apply for the 440 ATC’s.
Air setup and adjustment
Inspect the air tanks recharge pressure to make sure it is 95+PSI.
If it’s not, look at the compressor manufacture’s instructions to see if you can safely increase it.Set the FRL just below the tank's minimum. This will allow the machine receive air that does not fluctuate with the air compressor.
Example 1: My compressor starts to recharge at 90 PSI and goes all the way up to 105 PSI. I need to set my FRL to 88, 89, or 90 to get the most consistent results.
Example 2: My compressor starts to recharge at 80 PSI and goes all the way up to 100 PSI. I need to read through my compressor's manual to see if I can increase the minimum tank pressure or find another compressor that will be suitable for my machine.Readjust the drawbar to match the air pressure on the regulator as detailed in Power drawbar setup and adjustment.
...