Versions Compared

Old Version 4

changes.mady.by.user Sam Bollen

Saved on

compared with

New Version Current

changes.mady.by.user Sam Bollen

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Install the Flood Coolant Kit

Adjust the Coolant Pump Motor Strapping

...

  1. Put the loose end of the long coolant hose into the coolant manifold.

  2. Route the loose end of the self-retracting coolant hose through the rear of the Machine Stand, and then put it into the elbow on the coolant pump.

  3. Move the coolant tank into the Machine Stand.

  4. Route the power cord on the coolant pump to the rear of the electrical cabinet, and connect it to the Coolant Pump Power outlet.

  5. Verify that the coolant setup operates properly:

    1. From the PathPilot interface, on the Main tab, select Coolant.
      The coolant pump powers on.

    2. Select Coolant again.
      The coolant pump powers off.

  6. Secure coolant tank’s front panel to the Machine Stand with the two provided M8 × 1.25 – 16 flanged button head cap screws. Adjust the front panel alignment as necessary using the six mounting screws securing the front panel to the coolant tank.

...