Page Comparison

...

This video applies for all M Style Atc’s. Not everything will apply for the 440 ATC’s.

Air setup and adjustment

• Inspect the air tanks recharge pressure to make sure it is 95+PSI.
  If it’s not, look at the compressor manufacture’s instructions to see if you can safely increase it.

• Set the FRL just below the tank's minimum. This will allow the machine receive air that does not fluctuate with the air compressor.
  Example 1: My compressor starts to recharge at 90 PSI and goes all the way up to 105 PSI. I need to set my FRL to 88, 89, or 90 to get the most consistent results.
  Example 2: My compressor starts to recharge at 80 PSI and goes all the way up to 100 PSI. I need to read through my compressor's manual to see if I can increase the minimum tank pressure or find another compressor that will be suitable for my machine.

• Readjust the drawbar to match the air pressure on the regulator as detailed in Power drawbar setup and adjustment.

...