Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Current »

The xsTECH Router uses ER11 collets to hold tools.  To install a tool use the following procedure:

1. Click the collet into the collet nut

Do this before inserting the tool in the collet.

Collet_Installation.png

2. Insert the cutting tool

Place the tool into the collet and thread the collet on to the spindle so it is finger-tight.  You may find it easier to do this after re-positioning the table to the back of the xsTECH Router to provide more space. 

Insert_Tool.png

3. Tighten the collet nut on the spindle

Using the collet wrenches, finish tightening the collet nut so the tool is held firmly in the spindle.

tighten_wrenches.png
  • No labels

0 Comments

You are not logged in. Any changes you make will be marked as anonymous. You may want to Log In if you already have an account.