Unpack and Mount the Machine

Basic Installation Procedure

Follow the steps below to complete basic mill installation.

Partial Stand Assembly

The pedestal of the stand should be assembled first. Refer to documentation that ships with the stand for information on assembly. Do not install chip pans or backsplash until after mill has been lifted onto the stand.

Remove Accessory Tool Box

A wooden Tool Box is nailed to the pallet. This box contains tools that are required for installation. Carefully remove box from pallet using pry bar.

NOTE: The Spindle Lockout Key – used to lock or unlock the spindle – is located in the Tool Box. The spindle with not rotate without the key inserted in the Operator Panel.

Lift and Move Mill

WARNING! Transport and Lift Hazard: The transport, lifting, and moving of PCNC mill should be done by qualified professionals. Failure to do so may result in mill damage, serious injury or death.

Remove Mill from Pallet

The mill is secured to the shipping pallet with four bolts. Before attempting to lift mill, use wrench to remove nuts holding mill to pallet. This allows mill to be separated from shipping pallet when lifting.

Lifting Bar Kit

The preferred method for lifting the mill is from above, using the Lifting Bar Kit (PN 31446); as shown in Figure 3.5; use this method with either a forklift or engine hoist. The single Eye Bolt on the top of the column is suitable for lifting the entire weight of the mill. However, it is recommend that the Lifting Bar Kit be used. (see Figure 3.5 and Figure 3.6)

Refer to documentation that ships with Lifting Bar Kit for more information on use. Do not attempt to lift mill from above using any other method. If using an engine hoist, refer to the following table to determine the minimum distance necessary to straddle stand between hoist legs.

Open

Figure 3.5 Figure 3.6

Lifting from Below

It is also possible to lift the mill from below by inserting steel bars into two sets of opposing 7/8” diameter holes located in the machine base. The bars must be a minimum of 32” in length and should be made of solid steel. Do not use hollow pipe to lift mill.

WARNING! Crush Hazard: Keep hands and body parts clear when lowering mill onto stand. Failure to do so could result in serious injury or death.

Lowering Mill onto Stand

Position mill above stand and align one mill casting hole with one stand base hole; insert stud and thread into place. Repeat process for remaining three holes and loosely screw on four washers/nuts.

When mill is completely supported by stand, remove lifting tackle and tighten nuts to approximately 10 ft-lbs of torque.

Install Drip Tray

Unstrap stainless steel Drip Tray from pallet; use provided screws to install. (see Figure 3.8)

Open

Figure 3.8

Looking for more information?

This is a section of the PCNC 770 operator's manual. To view the whole manual, go to Tormach document UM10350.

If you have additional questions, we can help. Create a support ticket with Tormach Technical Support at tormach.com/how-to-submit-a-support-ticket for guidance on how to proceed.