Controller is Beeping on Boot Up - Tower Controller

Background

As your controller ages, there may be a time that will not properly boot up. In the case that you hear a beeping sequence upon boot up, follow this procedure to re-seat the computer's memory:

Tools

Screwdriver

Step 1:

Remove the screws that secure the exterior covers.

Step 2:

Push firmly on the back of the controller while sliding the exterior panels toward you.

Step 3:

Remove exterior panels from both sides

Step 4:

Pull tabs outward to remove the controller face.

Step 5:

Remove the screw that holds the disc drive in place.

Step 6:

Lift disc drive until released from the three securing tabs.

Step 7:

Carefully move the drive out of the way.

Step 8:

Press down on the white tabs to release the memory card.

Step 9:

Remove memory card and inspect card and slot. Reinsert the same way that you removed it, once inspected.

Step 10:

Reseat the memory card, on one side of the card and then the other. You will hear it snap into place once it seats. Reassemble your controller and reboot.