File tab:
...
From the File tab, you can do the following activities:
Transfer robot programs to or from USB drives.
Log into PathPilot HUB and transfer files from your online PathPilot account.
Edit robot programs.
Load files into PathPilot to run programs.
Create folders, rename, and move files within the system
...
.
There are three sections in the File tab:
The left-hand section displays locations on the controller's hard drive.
...
In the left window, you will This is where you can find robot programs that you have 've saved , or come that came with the controller. The root of this directory, accessible by pressing selecting the Home button, is located on the controller's hard drive at
~/nc_files/robot_programsclicking on a file entry will show you the code in the file preview window
...
.
If a USB drive is put into the controller, a middle section displays, which lists files stored on the USB drive.
The right-hand section is a preview of the currently highlighted file. If you select a new file, the code preview displays in this section.
Load a Robot Program
There are two ways to load a robot program from the file list:
Select a program in the file list by single clicking on it. Click ", and then select Load Program" (top right of disk location view) and the selected program will be loaded and the "Main Tab" will be activated (above the left-hand section). The selected program loads, and the Main tab displays.
Double click a program in the file list and that program will be loaded and the “Main Tab” will be activated. The selected program loads, and the Main tab displays.
Note:
...
If the program contains an error that prevents the interpreter from loading it, the error
...
displays on the
...
Status tab and the program
...
won’t load on the
...
Main tab. Resolve the error by editing the program and
...
try to load it again.
...
Edit a
...
Robot Program
Select a program in the file list by single clicking on it. Click “Edit Program” and the selected file will open , and then select Edit Program. The selected file opens in a code editor. The default code editor is PyCharm Community edition. The choice of which If you want to change the code editor to use can be made , you can do so on the settings Settings tab.
...
Edit a Robot Program Using Conversational Tab Features
Select a program in the file list by single clicking on it. Click “Conv. Edit” and the , and then select Conv. Edit. The main tab of the Conversational Notebook will be opened tab opens with the selected file active. From this tab, you may can add, delete, or reorder commands using the conversational programming features.