Machine Won't Power On - PCNC 770

Background

The idea of providing power to your machine seems simple: just plug it in. In reality, there are a number of other components used in order to provide power appropriately safety for you and the machine, including (but not limited to):

• The main disconnect switch

• Fuses and/or circuit breakers

• Emergency stop switch/button

• Separate latching circuits for the spindle and rest of the machine

• Transformers, which change the electricity to the appropriate value

Even with all of these components, you can systematically locate nearly any problem with just a multimeter.

Tools

• Multimeter

Twist Out the Emergency Stop Button

Reason: The Emergency Stop button is pushed in.

1. Twist out the Emergency Stop button and press the Reset button.

Reset the Building’s Mains Breaker

Reason: The shop or building’s mains breaker is turned off.

1. Examine the building’s breaker. If it’s not already on, turn it on.

2. Using a digital multimeter, measure to inspect and verify that you have power at the outlet.

Inspect the Power Entering the Machine

Reason: The Main Disconnect switch is in the Off position.

1. Examine the Main Disconnect switch. If it’s not already in the On position, turn it on and try to take your machine out of reset.

2. Measure the voltage coming out of your Main Disconnect switch.

3. Identify the wires as indicated in the table.

   1. If you measure the correct Vac, continue.

   2. If you do not any Vac, you either have a loose wire or a faulty Main Disconnect switch.

Check the FU1, FU3 and FU6 Fuses

Reason: Fuse is blown.

1. Identify your machines main fuses.

Open

2. Power down the machine, and remove both fuses.

3. Check both fuses using the following process: Checking a Fuse on a Tormach Machine

4. If any fuse is blown, replace it.