How do I install tools on the xsTECH Router?

Owned by Jacob Steuber
Last updated: Jul 31, 2024 by Sam Bollen
1 min read

The xsTECH Router uses ER11 collets to hold tools.  To install a tool, use the following procedure:

1. Click the collet into the collet nut

Do this before inserting the tool in the collet.

Collet_Installation.png

2. Insert the cutting tool

Place the tool into the collet and thread the collet on to the spindle so it is finger-tight.  You may find it easier to do this after re-positioning the table to the back of the xsTECH Router to provide more space. 

Insert_Tool.png

3. Tighten the collet nut on the spindle

Using the collet wrenches, finish tightening the collet nut so the tool is held firmly in the spindle.