Spaces
Apps
Templates
Create
PCNC 770 Knowledge Base
All content
Space settings
Content
Results will update as you type.
About Your Machine
Installation
Maintenance
PathPilot Basics
Troubleshooting
Spindle Troubleshooting
ATC Troubleshooting
•
Power Drawbar (PDB), Tool Won't Release - Legacy ATC
•
Pneumatic Seal Replacement for Leaking Drawbars
•
ATC Tab Disappears - Legacy ATC
•
Tray Won't Reference - Legacy ATC
•
Tray In Sensor Isn't Working - Legacy ATC
•
Tray is Moving Too Fast or Too Slow - Legacy ATC
•
Low Air Pressure or Malfunctioning Air Pressure Switch - PCNC 770
•
Check Fuses and Cables Error
•
Device Homing Error
•
Tray-In Sensor Fault
•
Manual Tool Change with Dead ATC Board - PCNC 770
•
Power Drawbar Foot Pedal Troubleshooting
•
Getting Out of an ATC Jam
Controller Troubleshooting
Motion System Troubleshooting
General Electrical Troubleshooting
Accessory Troubleshooting
You‘re viewing this with anonymous access, so some content might be blocked.
Close
PCNC 770 Knowledge Base
/
Tray-In Sensor Fault
Tray-In Sensor Fault
Sam Bollen
Owned by
Sam Bollen
Jan 07, 2025
Loading data...
{"serverDuration": 29, "requestCorrelationId": "cd5df5d0135f4d8ea9e0fdd2383bb4f0"}